...
- Media access control (MAC) address – the hexadecimal number that identifies a device on a network. MAC addresses (theoretically) are unique. Be assured that a given MAC address will be unique on your network
- Note – A text field that you can type notes to administratively describe information
- SIP URI – the SIP URI, for the last person to logon to the device
- IP Address – IP Address is the number assigned to a device on your network, and could be either IPv4 or IPv6. IP addresses are usually assigned using the dynamic host configuration protocol (DHCP) server or service on your network.
- Model – Lists the name of the phone model.
- Location – The defined physical location of the device if the Location is associated with a defined subnet configured in Locations
- Software – The version of software currently on the device.
- Last seen – Last time the device actively polled for updates or changes.
...
- Media access control (MAC) address – MAC address assigned to the device
- Note – A text field that you can type notes to administratively describe information
- SIP URI – Session initiation protocol uniform resource identifier (SIP URI) used for the SIP protocol to communicate with the device over TCP/IP
- IP Address – The assigned network/host address for communication with the device over TPC/IP
- Model – The detected model of the device
- Location - The location the device is located in
- Software – The detected software version currently on the device
- Last Seen – Time since the device last queried or checked for updates by way of a provisioning bridge
- Approved – Status of the device approval. A green check mark indicates that the device has been approved, a yellow triangle indicates that the device is waiting on administrative approval
Bridge this device connected to
...
- Bridge Name – The name of the bridge, as communicated to EZ UDM Pro, at the time of the bridge registration
- Device Logs –
- Device Specific Files –
- Version – The software version of the bridge
- Note – A text field that you can type notes to administratively describe information
- Devices - The number of devices connected to the bridge
- Status - Is the bridge approved
- Last Seen - the time elapsed since the bridge last connected successfully to the server. This is normally only a minute or 2
Device Logs
Logs that the device makes available to EZ UDM Pro through the bridge. This section is populated only if files are available.
If logs are available, you can do the following.
...
Configuration or other files (codecs, for example) such as Phone and Web Files that are specific to a unique set of devices. This section will be empty unless there are files for these devices for the device you are viewing.
Tags
A list of tags that are or could be applied to the device.If the order column is a number then this indicates the order in which the tag is applied to the device, if it is N/A then that tag is not applied to the device.
Config Entries
These list the Tags and Device Profiles contained in them that are applied to the device. The tags can be expanded to show the Device Profiles which in turn can be expanded to show the parameter in the Device Profile. The numbers in brackets indicated the number of entries applied out of the total number. For example (14/15) indicates that 14 entries were appied from the group and 1 will have been overridden by other Device Profiles further down the list. Entries that are over ridden are shown as crossed through, using the filter command you can display all the places a parameter is and if it is overridden.The screen shot below shows the example where the voIpProt.SIP.specialEvent.checkSync.alwaysReboot is initially set to 1 and then changed to 0
Actions
There are three actions that you can perform on your devices.
...